Submerged Transmission in Wave Energy Converters: Full Scale In-Situ Experimental Measurements


E Strömstedt – Uppsala University Doctoral Thesis, August 2012

Abstract
Different wave power technologies are in development around the world in different stages of prototype testing. So far only a few devices have been deployed offshore at full scale for extended periods of time. Little data is published about how these different devices perform.This thesis presents results from experiments with the full-scale offshore wave energy converters at the Lysekil research site on the Swedish west coast. The theories, experiments, measurements, performance evaluations and developments of the submerged transmission in the direct driven permanent magnet linear generator are in focus. The reciprocating submerged transmission fulfills the purpose of transmitting the absorbed mechanical wave energy through the capsule wall into the generator, while preventing the seawater from entering the capsule and reducing the life time of the converter.A measuring system with seven laser triangulation sensors has been developed to measure small relative displacements between piston rod and seal housing in the submerged transmission with excellent accuracy for the purpose of evaluating both functional behavior and successive wear in-situ. A method for calculating relative tilt angles, azimuth angles, differential tilt angles, and successive wear in the submerged transmission has been developed. Additional sensors systems have been installed in the converter enabling correlation and a thorough investigation into the operating conditions of the transmission and the converter. The thesis presents unique results from the measurements. A data acquisition system transmits the signals from the converter on the seabed to an onshore measuring station. Results are presented in time-, frequency- and the time-frequency domain.The results have given important information for further development of the submerged transmission, which is important to the survivability of the system. The thesis describes the status of research, and is a step that may influence future designs of wave energy devices for reaching survivability and a cost-effective renewable energy system.
Link

Advertisements

Leave a comment

Filed under Component Development

Leave a Reply

Please log in using one of these methods to post your comment:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s